Lower Inner Dome Prep

Ok so now its on to the lower section of the inner dome. First off it needs to be sliced vertically so it can be expanded some. This is pretty easy i just used the jig saw and cut right through the center where the Holoprojector near the dome bumps is.

Next i just took a piece of angled aluminum and cut a few L shaped peices to use as a spreader. This pushes out on the inner dome removing the gaps. They are secured to the inner dome using Captive Screws from http://www.mcmaster.com.

Once this was done i marked all of the panels that needed to be cut and then began cutting.

Here i temp taped some of the panels in place so i had a clear view where the front logic display would be mounted. 

More holes cut the same way i did for the top holoprojector.

More panels cutout and a quick test fit.